Weather: Sunny and mild. Winds: NW 10. Seas: <1ft.
Mid-morning departure, motoring out of the marina, squeezing between a couple boats moored behind us. Fortunately, it was calm and departure was easy. Exiting Victoria Harbor, we could sail!
One of the problems going to Canada is clearing customs on the way back (same for going into Canada...where to clear?). Entry into the US is at 3 locations, Roche Harbor, Friday Harbor or Anacortes: All are out of the way for a Victoria to Skyline run. The Anacortes entry is on the east side of town, where the primary marinas are located and way out of the way for us. Friday Harbor is also out of the way, less than Anacortes, but getting there means going through Cattle Pass, a pass where there be dragons if the transit timing is not at slack tide.
So, the only real option is Roche Harbor and our route home was determined by this. So, east along the Brotchie Ridge, to the south of Trial Island, to the east of Brodie Rock and Chain Islets in the Hacate and Plumper Passages, then NE into the Haro Strait via Baynes Channel. All under sail except for a brief period in vicinity of the west end of Baynes Channel when we needed to motor.
In the Haro, sailed NNE, making 6kts to Mosquito Pass and then had to motor into the customs dock. Briefly considered folding, but realized there probably was not much traffic so stayed spread. With no one at the customs dock, clearance in was easy. Friendly and chatty ICBP official was nice!
Motored most of the way towards home via Spieden Channel, across San Juan Channel to North Passage, through Pole Pass, Harney Channel and into Rosario via Thatcher Pass. There was wind in Rosario and we sailed home at 6.5kts!
Showing posts with label Customs/Immigration. Show all posts
Showing posts with label Customs/Immigration. Show all posts
Wednesday, October 16, 2013
Tuesday, 14August, 2012: Poet's Cove to Roche Harbor
Weather: Sunny and warm. Winds: Light. Seas: Calm.
Mostly a slow motor for the 10-sh nautical miles.
Since we were getting a slip in the marina, folded the amas upon arrival. Folding also made sense with the expected traffic at the customs and immigration dock.
Had heard some horror stories about clearing customs at Roche. Huge traffic jams, boats barging in and unhappy customs officials. RT was just clearing customs as we arrived. After a bit of radio chit chat, we were the 5th boat in line. While the line remained orderly, we hovered about and 30min later, a spot opened for us and we slipped right in.
I always get a kick out of the official's question about what I do for work. "Retired." "You are too young for retirement! What did you do?" "Navy!"
Turns out this CIBP official started out as a marine and then retired from the army. Nice guy and a nice chat!
Motor to our slip was uneventful!
Mostly a slow motor for the 10-sh nautical miles.
Since we were getting a slip in the marina, folded the amas upon arrival. Folding also made sense with the expected traffic at the customs and immigration dock.
Had heard some horror stories about clearing customs at Roche. Huge traffic jams, boats barging in and unhappy customs officials. RT was just clearing customs as we arrived. After a bit of radio chit chat, we were the 5th boat in line. While the line remained orderly, we hovered about and 30min later, a spot opened for us and we slipped right in.
I always get a kick out of the official's question about what I do for work. "Retired." "You are too young for retirement! What did you do?" "Navy!"
Turns out this CIBP official started out as a marine and then retired from the army. Nice guy and a nice chat!
Motor to our slip was uneventful!
Sunday, August 4, 2013
Friday, 20July2012: Reed Harbor to Bedwell Harbor, South Pender Island, BC
Weather: Sunny and warm. Winds: Variable. Seas: <1ft.
Another 'sail when we could, motor when we had to' day. Had some winds leaving Reed and managed to get near the center of Boundary Pass and then motored. As we approached South Pender, a NNE wind popped up and we beat towards the entrance of Bedwell. At the entrance, winds died and we motored to the custom's dock.
RT had motored the entire way and handed me the phone at the custom's office for check in. Waited on hold for about 20min then checked into Canada. Poet's Cove Marina is co-located with the custom's dock making this area a bit of a zoo. Which boats are in line for customs and which are attempting to get to the marina? Patience.
After clearing, motored out of the marina and took a provincial park mooring buoy...another first for us. Rafting is not allowed on these buoys. Fortunately, I was able to observe RT's mooring technique and being a good mimic, getting on the buoy was painless, monkeying with the harness is another story.
All my reading of trimaran anchoring and mooring buoys indicated the 'superiority' of the wide harness technique available to multihulls. That is, hooking the harness to the boat at the widest possible point, the outboard end of the akas. Did so, but also looped a mooring line through the buoy attached to the vaka as a back up. We were secure. What I don't like about the wide harness is there is so much line and this line can dip into the water and under the boat. Doesn't happen with sufficient wind to hold the boat off the buoy, but in calmer conditions it does. Still working on it...I hate reinventing the wheel.
During the afternoon, a S wind picked up and I sailed the dinghy around the harbor. Great fun, but I learned I needed to sit in the bottom of the boat, just too tippy. Later, after the wind died down, rowed Kelly to Poet's Cove for a little retail therapy. Along the way, a British lady from another boat popped up and asked "Is this your tender?" Yes. "Brilliant! I saw you sailing it around earlier. Brilliant!"
Lesson Learned: Getting on a mooring buoy.
Lesson Learned: Anchor/mooring ball harness needs work.
Another 'sail when we could, motor when we had to' day. Had some winds leaving Reed and managed to get near the center of Boundary Pass and then motored. As we approached South Pender, a NNE wind popped up and we beat towards the entrance of Bedwell. At the entrance, winds died and we motored to the custom's dock.
RT had motored the entire way and handed me the phone at the custom's office for check in. Waited on hold for about 20min then checked into Canada. Poet's Cove Marina is co-located with the custom's dock making this area a bit of a zoo. Which boats are in line for customs and which are attempting to get to the marina? Patience.
After clearing, motored out of the marina and took a provincial park mooring buoy...another first for us. Rafting is not allowed on these buoys. Fortunately, I was able to observe RT's mooring technique and being a good mimic, getting on the buoy was painless, monkeying with the harness is another story.
All my reading of trimaran anchoring and mooring buoys indicated the 'superiority' of the wide harness technique available to multihulls. That is, hooking the harness to the boat at the widest possible point, the outboard end of the akas. Did so, but also looped a mooring line through the buoy attached to the vaka as a back up. We were secure. What I don't like about the wide harness is there is so much line and this line can dip into the water and under the boat. Doesn't happen with sufficient wind to hold the boat off the buoy, but in calmer conditions it does. Still working on it...I hate reinventing the wheel.
During the afternoon, a S wind picked up and I sailed the dinghy around the harbor. Great fun, but I learned I needed to sit in the bottom of the boat, just too tippy. Later, after the wind died down, rowed Kelly to Poet's Cove for a little retail therapy. Along the way, a British lady from another boat popped up and asked "Is this your tender?" Yes. "Brilliant! I saw you sailing it around earlier. Brilliant!"
Lesson Learned: Getting on a mooring buoy.
Lesson Learned: Anchor/mooring ball harness needs work.
Subscribe to:
Posts (Atom)